Firmware Download

Changes from Version 1.21

• Changed the screen drawing sequence to keep the previous frequency screen layout when exiting from a function displayed in fullscreen.
• Fixed an issue where the standby beep may sound approximately two seconds after receiving a reply when simply pushing PTT to key up the repeater.

Changes from Version 1.22

• Fixed an issue where the DV Gateway function may not work properly when it is turned off and then turned on again.
• Fixed an issue where the RTTY DECODE screen was displayed while leaving the Mark Frequency and Shift Width settings at other than 2125Hz and 170Hz.

To update the firmware

• Thoroughly read 13. UPDATING THE FIRMWARE of the ADVANCED MANUAL and follow the instructions displayed on the IC-9700 LCD screen.
• This update initializes the transceiver's settings when updating from a firmware earlier than version 1.20. Save your current settings before updating the firmware, and then write it back to keep the previous setting on the updated firmware.
• The firmware will be updated to the following versions.
  Main CPU: 1.23
  Sub CPU: 1.00
  Front CPU: 1.00
  FPGA Program: 1.06
  FPGA Data: 1.00
  DV DSP: 1.06